Lighting

Programmable Timers

Programmable timers have been installed to control the club house soffit lights and pool deck post lamps. Provisions have been made to add a timer to the small pavilion lights in the future (wiring to the dual-gang junction box above the upstairs panel, RLP-2).

A Honeywell RPLS740B1008/U has been selected as the standard for this purpose. It features a 7-day solar time table (for automatic dawn/dusk control) and compatibility with LED and CFL bulbs. It is rated for:

• 1800 W (15 A) for resistive loads and non-tungsten lights (flourescent, CFL and LED)
• 1440 W (12 A) for tungsten loads (incandescent/halogen)
• 3/4 for motors/fans

Configuration

The timer is configured as follows:

• Latitude of +42° (north) and -83° (west) for Detroit/Livonia, MI
• A correction factor ("ADJ") of -1 (per the table in the manual)
• A single program (P01) with a turn-on at dusk, and a scheduled turn-off:
  • Midnight for the pool deck post lamps (for post-closing clean-up)
  • 2 am for the soffit lights (for aesthetics/security)

Power Failure

After a 4-hour power outage (per the manual - may be less, however), the time must be reset on the timers.

1. Press and hold the large button for 3 seconds to enter the setup menus.
2. Press the right small button to select "Time". Press the large button to select.
3. Press the large button to select 12-hour mode.
4. Press the left and right small buttons to set the hour, then the large button to save. Do the same for the minute, year, month and day.
5. The rest of the configuration should remain set. Press the large button to return to normal operation.

Bathroom

Content to follow.

Parking Lot

Content to follow.

Pavilion

Content to follow.

Pool (Underwater)

Content to follow.

Post-Mounted (Pool Deck)

Content to follow.

Soffit

Content to follow.